Subscribe to Blog via Email
Recent Comments
- Adding Low Oil Pressure Safety Stop to Kohler 7000 | Brian Gallimore's Blog on Wiring Schematic for Bad Boy ZTE Mower
- Philmont Scout Ranch Backpacking Trek 2026 | Brian Gallimore's Blog on Philmont Scout Ranch Backpacking Trek
- Elaine on Undocumented Secrets of Integrating BACnet MSTP
- Kent Hervey on Interior trailer lights
- Hector Flores on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
Top Posts
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Getting Ambient Weather Data into Ignition
- Wiring Schematic for Bad Boy ZTE Mower
- Comparing Plants Grown in Aquaponics and Soil
- Is McCain Mentally Unstable?
- The True Political Spectrum
- Plum-Flavored Sugar, Hold the Worms
- Do the Circle of Safety Walk
- Swivel Studs for Ruger 10/22 With Composite Stock
Resume
Bookmarks
Archives
Categories
-
Recent Posts
-
Meta
Tag Archives: tuning
Building a New VE Table
This is what I spent the better part of today working on, the VE table for Quadzilla. I’ve done this before, but now I’m dealing with a 2-bar OS, so I have double the range of pressure variables. There are … Continue reading
New Pulley for Quadzilla
So after a day of going through the vacuum system on Betty and failing to fix the transmission shift problem (but learning what all those plastic hoses go to), I decided to spend a little time on quadzilla. I’ve had … Continue reading
The next glitch
I did some adjusting to my Mass Air Flow calibration table and my Power Enrichment table to solve the previous issues. (now I’ve found that the GM computer is limited to 512 g/sec, which I’ve now exceeded) I made a … Continue reading
