Subscribe to Blog via Email
Recent Comments
- Adding Low Oil Pressure Safety Stop to Kohler 7000 | Brian Gallimore's Blog on Wiring Schematic for Bad Boy ZTE Mower
- Philmont Scout Ranch Backpacking Trek 2026 | Brian Gallimore's Blog on Philmont Scout Ranch Backpacking Trek
- Elaine on Undocumented Secrets of Integrating BACnet MSTP
- Kent Hervey on Interior trailer lights
- Hector Flores on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
Top Posts
- Earning 1% Per Week
- Private RoIP (Radio over IP) System
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Do the Circle of Safety Walk
- Adding Low Oil Pressure Safety Stop to Kohler 7000
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Undocumented Secrets of Integrating BACnet MSTP
- Wiring Schematic for Bad Boy ZTE Mower
- Differential Damage
- 12 Ton Shop Press
Resume
Bookmarks
Archives
Categories
-
Recent Posts
-
Meta
Tag Archives: rear end
More Rear-End Fun
Today was filled with lots of assembly, measurement, disassembly, re-shim, assembly, measure, repeat. I think I have everything within spec now, and my mesh pattern looks good (to me at least). Tomorrow, I’m going to add an extra 5 thousandths … Continue reading
What Gears Should I Use
I need to decide which ring and pinion gears to use. (currently have 3.73) I was thinking I wanted 4.30’s, but now I’m considering 4.56. Conventional wisdom says my gas millage will go down, but I’m not convinced of that. … Continue reading
