I changed out the belts on quadzilla today. Without the supercharger, this is a 4 minute job, with the supercharger, it takes me a couple of hours. I have to take off the intake tubes, the fan shroud, and finally the supercharger and bracket. The big belt snakes through a bunch of bolts/spacers that have to be completely removed to change it out. The bearings in one of the idler pulleys was going bad and making lots of noise. This is the fourth idler pulley I’ve had to replace. PITA. Anyway, when I was getting it cleaned up, the big ProCharger emblem was loose, so I just took it off so I could clean the grim good. I was surprised when I saw my name written underneath the emblem. I feel special now, they assembled this blower just for me!
Subscribe to Blog via Email
Recent Comments
- Bill Roberge on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Brian Gallimore on Wiring Schematic for Bad Boy ZTE Mower
- Brian Gallimore on DIY Automatic Transfer Switch
- Robert O. Heslop on Wiring Schematic for Bad Boy ZTE Mower
- Brian Gallimore on Philmont Scout Ranch Backpacking Trek
Top Posts
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Troy Bilt Chipper Shredder Review
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Private RoIP (Radio over IP) System
- Razor Dune Buggy w/ 500w motor, 36v battery
- Curious George Live!
- The True Political Spectrum
- Time Average in Ladder Logic (ControlLogix AOI)
- Raspberry Pi Data to Google Sheets
Resume
Bookmarks
Archives
Categories
-
Recent Posts
Meta