I love drilling holes in nice things. This was my first time to use an abrasive hole saw, and it was an impressive experience, went right through the brick and mortar wall. I installed a large waterproof junction box with some cable clamps on the bottom edge, then ran a power cord and the air line through the box. It cleaned up the install, I had the cable and hose running underneath the garage door.
Subscribe to Blog via Email
Recent Comments
- Kent Hervey on Interior trailer lights
- Hector Flores on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Bill Roberge on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Brian Gallimore on Wiring Schematic for Bad Boy ZTE Mower
- Brian Gallimore on DIY Automatic Transfer Switch
Top Posts
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Wiring Schematic for Bad Boy ZTE Mower
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Private RoIP (Radio over IP) System
- A nostalgic story from someone else's childhood
- The True Political Spectrum
- Troy Bilt Chipper Shredder Review
- Debounce Code for Logix 5000
- Why Plain Text is Best
- Calculating the Volume of Irregular-Shaped Tanks
Resume
Bookmarks
Archives
Categories
-
Recent Posts
-
Meta
I can see inside your garage.