The growbed is ready to be moved into position and filled with rock. Tuesday night, I installed 1″ foam insulation board on the inside surfaces. This changed the dimensions to 36″ x 91″ x 12″. (area: 22.75 square feet or 2.1 square meters; volume: 22.75 cubic feet or 170 gallons or 644 liters). Tonight, I installed the pond liner and the drain. Turns out the pond liner is cut a few inches bigger, so I had enough material to fold over the top edge of the growbed sides.
Subscribe to Blog via Email
Recent Comments
- Bill Roberge on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Brian Gallimore on Wiring Schematic for Bad Boy ZTE Mower
- Brian Gallimore on DIY Automatic Transfer Switch
- Robert O. Heslop on Wiring Schematic for Bad Boy ZTE Mower
- Brian Gallimore on Philmont Scout Ranch Backpacking Trek
Top Posts
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Time Average in Ladder Logic (ControlLogix AOI)
- Private RoIP (Radio over IP) System
- Debounce Code for Logix 5000
- Swivel Studs for Ruger 10/22 With Composite Stock
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Curious George Live!
- Convert Allen Bradley Logix 5000 Time to Unix Time (Epoch)
- Milton Friedman on the Ford Pinto
- Troy Bilt Chipper Shredder Review
Resume
Bookmarks
Archives
Categories
-
Recent Posts
Meta