Rather than buy a heat mat, I wanted to build something instead. My first plan was to build a wooden box and insulate it, but then I ran across this styrofoam cooler. I built a little shelf out of scrap plywood, with a 25w lightbulb mounted near the center. The only thing I didn’t have on hand was the cord plug. I’ll put my pots on the wood shelf, then cover the top with the lid, or maybe some plastic.
Subscribe to Blog via Email
Recent Comments
- Kent Hervey on Interior trailer lights
- Hector Flores on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Bill Roberge on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Brian Gallimore on Wiring Schematic for Bad Boy ZTE Mower
- Brian Gallimore on DIY Automatic Transfer Switch
Top Posts
- Wiring Schematic for Bad Boy ZTE Mower
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Private RoIP (Radio over IP) System
- 5 Gun Posters and Gun Quotes
- Time Average in Ladder Logic (ControlLogix AOI)
- Bucky Roberts and TheNewBoston.org
- Tippmann A5 2.0.1 and 2.0.2
- Dasher's Warble Fly
- The True Political Spectrum
Resume
Bookmarks
Archives
Categories
-
Recent Posts
-
Meta
The 25W bulb is too much heat! I’ve had the lid sitting on top, slid to one side so that there is a 1″ gap of air, and the soil temperature is 105 degrees F. (outside air is 40 to 50 degrees F) I think I might have just cooked my seeds.
Installed a 11W bulb, placed lid on top, elevated about 1″ above rim of cooler. The soil temperature at the bottom of the pots was about 88 degrees F, and 78 degrees F near the top. I also ordered a line voltage thermostat (baseboard heater thermostat) to play with later.