Just wanted to post the pictures I took of this little tablet while I had it apart. There are videos on youtube that are very helpful in learning where to pry and which screws to take out for the job. One thing I didn’t get right was getting the screen loose from the bezel. My LCD screen came loose from the digitizer glass but left the polarizing filter attached to the glass. I couldn’t peel it off without breaking the filter. Another unexpected thing was how the bezel was made, it has 2 layers of plastic, not one. I thought I was prying the glass off, but was really prying the two layers apart.
Subscribe to Blog via Email
Recent Comments
- Tw on DIY Automatic Transfer Switch
- Arby Arbutina on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Algorithm Is The New Rhetoric - Victory Girls Blog on The Legacy of Andrew Breitbart
- Ian on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Ray Cook on Private RoIP (Radio over IP) System
Top Posts
- Private RoIP (Radio over IP) System
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Debounce Code for Logix 5000
- Raspberry Pi Data to Google Sheets
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Wiring Schematic for Bad Boy ZTE Mower
- Time Average in Ladder Logic (ControlLogix AOI)
- Troy Bilt Chipper Shredder Review
- 5 Gun Posters and Gun Quotes
- Use Logix GSV WallClockTime for Pulse Bit
Resume
Bookmarks
Archives
Categories
-
Recent Posts
Meta