I managed to get the TinyTrackerII soldered together earlier in the week, and tonight I started testing it. I had to wire up a TTL to RS232 converter to get it to talk with my laptop. I was able to configure the parameters, but haven’t set the audio levels with the radio interface yet. I also powered up the $17 GPS receiver, and it is spitting out NMEA serial data as it should. My GPS antenna seems to have been delivered to the wrong place, so I still don’t have it.
Subscribe to Blog via Email
Recent Comments
- Elaine on Undocumented Secrets of Integrating BACnet MSTP
- Kent Hervey on Interior trailer lights
- Hector Flores on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Bill Roberge on Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Brian Gallimore on Wiring Schematic for Bad Boy ZTE Mower
Top Posts
- Wiring Schematic for Bad Boy ZTE Mower
- Time Average in Ladder Logic (ControlLogix AOI)
- Quadrasteer / Dana 60 Axle Differences and Similarities
- Private RoIP (Radio over IP) System
- Camping Gear
- The Basis for Law is Religion
- Check your Automotive Insurance Prices
- Quadrasteer / Dana 60 Rebuild How-To (ring, pinion, carrier replacement)
- Statue returns to Italy
- Presidential Character
Resume
Bookmarks
Archives
Categories
-
Recent Posts
-
Meta
